Mercedes S-Class W-140

1991-1999 of release

Repair and operation of the car



Mercedes S-Class
+ Mercedes-Benz cars of the class S (W-140)
+ Operation manual
+ Routine maintenance
- Engine
   Check of a compression in engine cylinders
   Check of the engine by means of the vacuum gage
   Belt of the streaming drive of auxiliary units
   + 6-cylinder petrol engines (M104.944 and M104.990/994)
   + 8-cylinder petrol engines (M119.970/981 and M119.971/981)
   + 12-cylinder petrol engines (M120.980/982)
   - 6-cylinder diesel engines (OM603.971)
      The air cleaner - installation details
      Replacement of a belt of the drive of the generator
      Removal and installation of a natyazhitel of a belt of the drive of the generator
      Final collector - installation details
      GRM drive chain cover
      Camshaft
      Removal and installation of a head of the block of cylinders
      Verification of the control provision of the camshaft
      Replacement of a chain of the GRM drive
      The GRM drive - the general information, service of components
      Natyazhitel of a GRM drive chain - an installation detail
      Removal and installation of pistons
      Check of a state and replacement of rods
      Measurement of diameters of cylinders
      Removal and installation of sleeves of cylinders
      Check of a condition of a bent shaft
      Removal and installation of an asterisk of a bent shaft
      Removal and installation of the pallet of a case of the engine
      The oil level sensor switch - installation details
      Replacement of a chain of the drive of the oil pump
      Removal and installation of the oil pump
      Removal and installation of the case of an oil filter
   + 6-cylinder diesel engines (OM606.961)
+ Cooling systems, heating
+ Power supply system and release
+ Engine electric equipment
+ Gear shifting box
+ Automatic transmission
+ Coupling
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment






Replacement of a belt of the drive of the generator

Removal

Details of installation of a belt of the drive of the generator




 PERFORMANCE ORDER

1. Weaken a casing of the fan and fix it over the fan.
2. Remove the fan coupling.
3. Weaken a generator drive belt.
4. Turn off a nut (378), a bolt (375) and take off a generator drive belt.
5. Check a belt for absence of damage.

Installation

Scheme of laying of a belt of the drive of the generator

1 — the Tension roller
2 — the Bent shaft
3 — the conditioner Compressor
5 — the Generator

7 — the Pump of the amplifier of steering
7/1 — the Directing roller
8 — the cooling system Pump

Installation is carried out as it should be, the return to removal. Belt length: without conditioner - 2080 mm, with the conditioner - 2145 mm.












58b5488c