Mercedes S-Class W-140

1991-1999 of release

Repair and operation of the car



Mercedes S-Class
+ Mercedes-Benz cars of the class S (W-140)
+ Operation manual
+ Routine maintenance
+ Engine
+ Cooling systems, heating
+ Power supply system and release
+ Engine electric equipment
+ Gear shifting box
+ Automatic transmission
+ Coupling
+ Brake system
- Suspension bracket and steering
   Security measures
   Angles of installation of wheels of the car, clearance
   + Forward suspension bracket
   - Back suspension bracket
      Stupichny assembly - installation details
      Removal and installation of a screw spring
      The stabilizer of cross stability - an installation detail
      Removal and installation of the shock-absorber
      Removal and installation of a back depreciation rack (model with hydraulic adjustment of a suspension bracket)
      Check of the hydraulic pump
      Removal and installation of the accumulator of pressure of a hydraulic actuator of a back suspension bracket (model with a code 217a "A self-regulating back suspension bracket with ADS" and a code 480 "Management of clearance of a back suspension bracket")
      Removal and installation of the control unit of clearance of a back suspension bracket
      Damping valves - installation details
      Removal and installation of the valve of adjustment of clearance
      Regulator of clearance of a back suspension bracket
   + Steering
+ Body
+ Onboard electric equipment






Removal and installation of a screw spring

Details of installation of a screw spring of a back suspension bracket

Removal

 PERFORMANCE ORDER

1. Lift the car.
2. Remove a guard (72) from the lower lever.
3. Remove cross draft (69).
4. Disconnect conducting from the indicator of wear of a brake slip from the lower lever (72) (shooter).
5. Establish the squeezing plates (01b) and (01c).
6. Lift the lower lever (72) so that a power shaft was established in completely horizontal position.
7. Install the squeezing device (01) for a spring.
8. Squeeze a spring.
9. Disconnect the lower lever (72).
10. Remove a spring (73) with the plug (74), wipe the lower lever (72).

Installation

Installation is carried out as it should be, the return to removal.

Replace a nut (72b) and bolts (69a) and (69b). Make sure that conducting of the indicator of wear of a brake slip is established correctly.





58b5488c