Mercedes S-Class W-140

1991-1999 of release

Repair and operation of the car



Mercedes S-Class
+ Mercedes-Benz cars of the class S (W-140)
+ Operation manual
+ Routine maintenance
+ Engine
+ Cooling systems, heating
+ Power supply system and release
+ Engine electric equipment
- Gear shifting box
   Specifications
   Removal and installation of the transmission
   Forward cover of the transmission - an installation detail
   Removal and installation of a back cover of the transmission
   + RKPP 717.438
   - RKPP 717.454
      Removal and installation of the sensor of speed of the car (VSS)
      Removal and installation of a forward cover of the transmission
      Removal and installation of a back cover of the transmission
      Removal and installation of an intermediate case
      Replacement of an epiploon of a back cover of the transmission
      Removal and installation of shaft of the transmission
      Dismantling and assembly of an intermediate shaft
      Verification of dimensional characteristics of the transmission
      Replacement of conic roller bearings of an intermediate shaft
      Replacement of ball bearings of an intermediate shaft
      Adjustment of the mechanism of gear shifting
+ Automatic transmission
+ Coupling
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment



58b5488c

Adjustment of the mechanism of gear shifting

Details of installation of elements of the mechanism of gear shifting

Gear shifting mechanism design

201 — the Decorative handle
202 — the Casing
203 — the Nut
204 — the gear shifting Lever
206, 221 — Springs
204, 226 — Lock rings
218, 211 — Plugs
209, 225, 279 — Fingers
310 — a switching Fork

213, 227, 233 — Bolts
216 — a bearing Cover
218, 220, 239, 240 — Laying
224 — the Lock eye
230 — the Arm of bearings
231 — the Lock plate
230 — Plastic laying
236, 237, 238 — Intermediate levers of switching


 PERFORMANCE ORDER

1. Install the lever of gear shiftings in neutral situation, then disconnect switching levers from drafts of switching on the gear shifting mechanism after removal of lock clips (37).
2. Arrange three intermediate levers in the following sequence: transfer back the хода/1st - I am transfer, 2/3 transfer and the 4/5th transfers and block them a lock finger through openings.
3. Weaken lock nuts (arrows) and adjust length of each draft.
4. Remove a lock finger from intermediate levers of gear shifting.
5. Check gear shifting at the working engine.